Connect Tech NT960/PCI Instructions d'exploitation télécharger pdf (Page 90)

M300USERSGUIDE SEA

DATAOPERATIONS



For the first M300 session.

Start the M300 and then change the UDP broadcast settings.

To change the UDP settings for the M300 (See “General Tab” on page 76).

We will setup the Port Name to sea-udp (port 2001).

Then we can follow the instructions for UDP mode, (See “UDP” on page 84).

Make sure you load the correct project for the data that you are receiving. This project should match

the same M300 project that is being used to broadcast the data.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 205 206

Pas de commentaire

Connect Tech NT960/PCI Instructions d'exploitation Page 90